NEC Xen Master Programming Manual page 185

Programming Manual
Automated Attendant Extension
Number Assignment
General Description
Use this Memory Block to assign the extension number of each AA message.
Display
Data
No. Title
2 1 : A A M S G 1
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 + BA
3 Use the dial pad to enter data.
Note: Use the following to enter data:
A ~ H to enter Automated Attendant message number
KK ~ II
KKK III
~
KKKK
(Depends what length the extension number has been assigned in HB1-2-03.)
N
4 Press to write the data, and advance to the next A.A.No.
5 After the last entry, press
P
6 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2 Guide to Feature Programming
N
1. Extension number should not be the same as the physical extension, CAR, ACD/UCD/SCD pilot number.
2. This memory block is applicable to main software Release 4.0 and above.
Automated Attendant Extension Number Assignment
A.A. Msg.
No.
Setting
1~8
Data
=
D I S P L A Y
to access the Memory Block.
,
,
~ IIII
N
to write the data.
Memory Block Name
May 2003
System Mode
1
Submode
4
Data No.
21
PC Programming
a
+AU
Default Values
Not assigned.
1-4-21
1 - 167