Connecting The 24 V Terminal Adapter; Connecting Ep Terminals/Temperature Sensor; Shield Connection - Siemens Sinamics S120 Manual

6.5.6

Connecting the 24 V terminal adapter

The 24 V voltage can be supplied to or tapped from a component by means of the 24 V
terminal adapter.
The 24 V terminal adapter can be installed in every Line Module, Motor Module, and Control
Supply Module. It is suitable for connecting cable cross-sections of 0.5 up to 6 mm
24 V terminal adapter
Additional information can be found in the SINAMICS S120 Manual "Booksize Power Units"
(GH2).
6.5.7

Connecting EP terminals/temperature sensor

6.5.7.1

Shield connection

Shield connection for terminals X21/X22 on the Motor Module
The figure below illustrates the shield connection for cables routed to terminal X21.
The following make of shield connection clamp must be used: Weidmüller, type KLBÜ 3-8
SC
Figure 6-3
Note
Correct shield connection for Single Motor Modules
A Single Motor Module can also have both terminals X21 and X22. The shield connection
must be made at X21. Terminal X22 has no function.
Power Units in Booksize C/D-Type Format
Manual, 01/2017, 6SL3097-4AC20-0BP1
Shield connection for X21
6.5 Electrical connection
Article No.
6SL3162-2AA00-0AA0
Cabinet design
.
2
101