6. Connect the HALL sensor daughter board FPC and docking connector FPC to the connector on the system board and close
the latch.
Next steps
1. Install the
display
assembly.
2. Install the
SIM
tray.
3. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
SIM
tray.
3. Remove the
display
assembly.
4. Remove the
WWAN
card.
5. Remove the
left system
6. Remove the
right system
7. Remove the
solid-state
8. Remove the Microphone.
9. Remove the kickstand.
10. Remove the
kickstand
11. Remove the
heat
sink.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
fan.
fan.
drive.
hinges.
computer.
computer.
Removing and installing components
59