System Board; Removing The System Board - Dell Inspiron 16 5645 Owner's Manual

Table of Contents

Figure 40. Installing the power-adapter port

Steps

1. Align and place the power-adapter port in the slot on the palm-rest and keyboard assembly.

NOTE:

The power-adapter port is secured in place by the hinge. There is no screw, tape, or adhesive securing the

power-adapter port to the palm-rest.Technicians should ensure that the power-adapter port has not fallen out when the

right hinge is removed.

2. Route the power-adapter port cable through the guide on the palm-rest and keyboard assembly.

3. Connect the power-adapter port cable to its connector (DCIN) on the system board.

4. Press the hinge down to align the screw holes on the hinge to the screw holes on the system board and the palm-rest and

keyboard assembly.

5. Replace the two screws (M2.5x5) that secure the hinge to the system board and the palm-rest and keyboard assembly.

Next steps

1. Install the

base

cover.

2. Follow the procedure in

System board

CAUTION:

The information in this section is intended for authorized service technicians only.

After working inside your

computer.

Removing and installing Field Replaceable Units (FRUs)

Table of Contents

P131f