Installing The Display Assembly - Dell Latitude 7320 Detachable Service Manual

4.
CAUTION: Make sure that the system has already been powered off before removing the screws.
Remove the four (M1.6x4) screws securing the display panel to the display back cover.
5. Using a plastic scribe, push the two release holes next to the kick stand hinges to loosen the display assembly from the
display back cover.
6. Close the kick stand and flip the computer over with the display facing upwards.
7. Using a plastic scribe, pry open the display panel from the bottom-left or bottom-right corner.
8. Work your way around the top and remaining sides of the display panel.
9. Gently flip open the display assembly from the top edge and lay the display panel assembly face down.
CAUTION: Do NOT pull the display panel away from the base while the display panel is still connected to the
system board.
10. Slide the power switch on the system board from "PD1" to "PD2".
NOTE: After switching the power switch off, an LED indicator next to the switch will illuminate red, indicating that
power has been cut-off from the computer.
11. Remove the two (M2x2.5) screws that secure the display cable bracket to the system board.
12. Remove the display cable bracket from the computer.
13. Disconnect the display cable from the system board and remove the display assembly from the computer.

Installing the display assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
Removing and installing components 17