Steps
1. Align and place the smart card reader on the frame.
2. Replace the three (M2x2) screws that secure the smart card reader to the frame.
3. Connect the smart card reader FPC to the connector on the USH board and close the latch.
4. Place the smart card reader support brackets on the smart card reader.
5. Replace the three (M2x2) screws that secure the smart card reader support bracket to the frame.
Next steps
1. Install the battery.
2. Install the
system
board.
3. Install the
heat
sink.
4. Install the
kickstand
hinges.
5. Install the kickstand.
6. Install the Microphone.
7. Install the
solid-state
8. Install the
right system
9. Install the
left system
10. Install the
WWAN
card.
11. Install the
display
assembly.
66
Removing and installing components
drive.
fan.
fan.