Installing The Battery - Dell Latitude 7320 Detachable Service Manual

3. Disconnect the battery cable connector from the system board.
4. Remove the six (M2x3) screws that secure the battery to the frame.
5. Lift the battery out of the system.

Installing the battery

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Align and place the battery into the system.
2. Replace the six (M2x3) screws that secure the battery to the frame.
3. Connect the battery cable to the system board.
4. Replace the single (M1.6x3.4) screw that secures the battery cable connector to the system board.
5. Affix the HALL sensor daughter board FPC and docking connector FPC on the battery.
58 Removing and installing components