Steps
1. Align and place the Hall sensor daughter board into the slot on the frame.
2. Replace the single (M2x2) that secures the Hall sensor daughter board to the frame.
3. Affix the Hall sensor daughter board FPC to the battery.
4. Connect the Hall sensor daughter board FPC to the connector on the system board and close the latch.
Next steps
1. Install the
display
assembly.
2. Install the
SIM
tray.
3. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
CAUTION:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
2. Remove the
SIM
card.
3. Remove the
display
assemly.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
44
Removing and installing components
After working inside your
before working inside your
computer.
computer.