Led Indications; Adjust The Brightness Of The Led Indicator - Yaesu FTDX10 Operation Manual

LED Indications

Displays the transmit/receive status of the transceiver, and the MPVD ring "FINE" and "STEP".
RX Indicator
BUSY: This indicator illuminates when the squelch
opens.
TX: This indicator illuminates during transmission.
Memory Mode RX/TX Indicators
Green (Left):
This indicator illuminates when the receiver is ac-
tive on the memory channel.
Red (Right):
This indicator illuminates when the transmitter is
active on the memory channel.
VFO-A RX/TX Indicators
Green (Left):
This indicator illuminates when the receiver is ac-
tive on the VFO-A.
Red (Right):
This indicator illuminates when the transmitter is
active on the VFO-A.

• Adjust the brightness of the LED indicator

Adjusts the brightness (illuminance) of the LED indicator.
1. Press the [FUNC] knob.
2. Touch [DISPLAY SETTING] or rotate the
[FUNC] knob to select [DISPLAY SETTING]
and then press the [FUNC] knob.
3 . T o u c h [DISPLAY] → [LED DIMMER] or
rotate the [FUNC] knob to select an item and
press the [FUNC] knob.
TX Indicator
Memory Mode VFO-A
RX/TX RX/TX
Indicators Indicators
Fine Tuning Indicator
VFO-B STEP Indicator
RX/TX
Indicators
VFO-B RX/TX Indicators
Green (Left):
This indicator illuminates when the receiver is ac-
tive on VFO-B.
Red (Right):
This indicator illuminates when the transmitter is
active on the VFO-B.
FINE: This indicator illuminates when the frequency
can be adjusted in 1 Hz steps by the MPVD
ring.
● The AM, FM, DATA-FM modes may be ad-
justed in 10Hz steps.
STEP: This indicator illuminates when the frequency
changes at predetermined steps of the MPVD
ring.
4. Rotate the [FUNC] knob, or touch "<" or ">"
on either side of the value to adjust the bright-
ness.
5. Press the [FUNC] knob to save the new set-
ting.
6. Touch [BACK] several times to return to nor-
mal operation.
31