Yaesu FTDX10 Operation Manual page 41

BAND (Operating Band Selection)
Touch the display to select
Press the [BAND] key, the operation band selection
screen appears on the display, so touch the desired
band. When you touch it, the band will be con-
firmed for about 2 seconds and then return to the
operating screen.
Rotate the MPVD ring to select
Press the [BAND] key, the operation band selection
screen appears on the display. Rotate the MPVD
ring to select the desired band. After about 2 sec-
onds of selection, the band will be confirmed and
the operation screen will return.
FINE TUNING (Tuning of 1 Hz)
In the LSB, USB, CW-L, CW-U, DATA-L, DATA-U,
RTTY-L, RTTY-U or PSK mode, the frequency can
be adjusted in 1 Hz steps.
● The AM, AM-N, FM, FM-N, DATA-FM and
D-FM-N modes may be adjusted in 10 Hz steps.
1. Press the [FINE] key.
The LED on the [FINE] key lights orange and the
"FINE" indicator lights.
2. Rotate the MAIN dial knob.
3. Press the [FINE] key again to return to the origi-
nal frequency step.
40
MODE (Operating Mode Selection)
Touch the display to select
Press the [MODE] key or touch the operation mode
area, the operation mode selection screen appears
on the display, so touch the desired mode.
Rotate the MPVD ring to select
Press the [MODE] key or touch the operation mode
area, the operation mode selection screen appears
on the display. Rotate the MPVD ring to select the
desired mode.
When changing modes from SSB to CW,
the frequency will shift on the display, even
though the actual tone that is heard does
not change.
This shift represents the BFO offset between
the "zero beat" frequency and the audible
CW pitch (tone). The pitch is programmed
via Menu item "CW FREQ DISPLAY" page
96).