Other Functions
Band Stack Operation
The FTDX10 employs a triple band-stack VFO
selection technique that permits storing up to
three favorite frequencies and modes onto each
band VFO register.
A typical setup, for the 14 MHz band, might be
arranged like this:
1. Program 14.0250 MHz, CW-U Mode, then
press the [14] key.
2. Program 14.0800 MHz, RTTY-L Mode, then
press the [14] key.
3. Program 14.1950 MHz, USB Mode, then
press the [14] key.
With this configuration, successive momentary
presses of the [BAND] key and then touching
[14] will step sequentially through the three Band
Stack VFOs.
【BAND】 【14】
【BAND】 【14】
76
TOT (Time Out Timer)
The "Time-Out Timer" (TOT) shuts the transmitter
OFF after continuously transmitting for the pro-
grammed time.
1. Press the [FUNC] knob.
2. Select [OPERATION SETTING]→[GENER-
3. Rotate the [FUNC] knob, or touch "<" or ">"
4. Press the [FUNC] knob to save the new set-
5. Touch [BACK] several times to return to nor-
【BAND】 【14】
AL]→[TX TIME OUT TIMER].
on either side of the value to select the TOT
countdown time (1 -30 min or OFF).
ting.
mal operation.
The beep sounds at about 10 seconds before
returning to receive mode automatically.