Meter (MAIN band)
There are four functions on the main multi-meter.
The bottom three selections in the list below are
transmit functions.
Indicates the received signal strength on
S:
the MAIN band, from S-0 to S9+60 dB.
Indicates the RF Power Output, from 0 to
PO:
150 Watts on transmit.
COMP: Indicates the compression level of the
speech processor, from 0 to 20 dB.
TEMP: Indicates the final transistor temperature,
from 0 °C to 100 °C.
Frequency Display
Left side: MAIN band frequency display.
Right side: SUB band frequency display.
Filter Display
This indicator is used for viewing the status of the
Meter (SUB band)
bottom four selections in the list below are transmit
functions.
Indicates the received signal strength on
S:
the SUB band, from S-0 to S9+60 dB.
Indicates the relative ALC voltage.
ALC:
VDD
ID
SWR: Indicates the antenna system observed-
Display indications
Operation status display
BUSY:
TX:
+:
-:
ENC:
TSQ:
SPLIT:
SYNC:
CLAR TRX
CLAR TX
CLAR RX
+xxxHz/-xxxHz
VFO mode/MEMORY mode
VFO: Displayed in VFO mode.
M-xx: Displays the selected channel number when
in memory mode.
Mode (radio modulation form)
Receive operation status indication
Displays the operation status of each reception
function.
You can change the setting by touching.
Indicates which antenna is selected by
ANT:
[ANT] on the display.
Indicates which front end RF amplifier is
IPO:
selected [IPO] on the display.
Indicates the attenuation level, selected
ATT:
[ATT] on the display.
AGC: Indicates the AGC decay time setting,
which is selected [AGC] on the display.
Indicates the Digital Notch Filter is ON/OFF.
DNF:
Receiving signal
Transmitting
Plus shift
Minus shift
The tone encoder is in use
During tone squelch operation
Running split operation
During synchro operation
13