Yaesu FTDX10 Operation Manual page 20

Operation of the display [FUNC] knob
Displays the multiple functions that may be operated when the [FUNC] knob is pressed.
Normally, it is recommended to adjust the level of the spectrum scope with the [LEVEL] knob.
The last used function is recalled when the [FUNC] knob is pressed. Therefor you can easily call up and
then set a function by turning the [FUNC] knob.
To change the function of the [FUNC] knob, touch the desired item that appears on the function screen
when the [FUNC] knob is pressed, or turn the [FUNC] knob to select an item and then press the [FUNC]
knob.
FUNC knob
The following settings and operations can be performed with the [FUNC] control.
LEVEL
: Adjust the reference level to make it easier to distinguish the scope display target signal
from the noise.
PEAK
: Adjust the Peak Signal Color Density.
MARKER : ON/OFF Marker indicates the transmit and receive frequency position within the Scope
Display image.
COLOR : Changes the scope display color.
CONTRAST : Adjust the contrast of the TFT display.
DIMMER
: Adjust the brightness of the TFT display.
M-GROUP : Memory group selection.
MIC GAIN
: Adjusts the microphone gain.
MIC EQ : Three-Band Parametric Microphone Equalizer is turned ON/OFF.
PROC LEVEL
: Adjusts the Speech Processor Gain.
AMC LEVEL : Adjusts the AMC (Automatic Microphone Gain Control) Gain.
VOX GAIN : VOX gain setting.
VOX DELAY : VOX delay setting.
ANTI VOX : Anti-VOX Settings.
RF POWER : Transmit power setting.
MONI LEVEL : Monitor level adjustment.
KEYER
: Built-in electronic keyer is turned ON/OFF.
BK-IN : CW Break-in function is turned ON/OFF.
CW SPEED
: Adjusts the desired sending speed.
CW PITCH : Adjusts the CW tone when receiving the CW signal and the side tone monitor.
BK-DELAY
: Adjust the hang time after the CW transmitting ends.
DNF : Digital Notch Filter function is turned ON/OFF.
Operation of the FUNC knob
19