Main Receiver Display Indications - Yaesu FT-1000MP Operating Manual

General Information
Main Receiver Display Indications
STEELE EE LEE Co
1516 1718 19 20 21 22 23
3 mia
i:
CAT
aM OUAL TA Da Dm a a
) ae@ae@en
= ———— re |
4 Boog o.oo
CO,
6 f BO TH 2
(1) (SUD
This appears when the PTT is keyed and
transmission is occurring.
(2) Gs
This appears whenever the Main receiver
squelch is open (VFO-A).
(3)
This appears whenever the Sub receiver
squelch is open (VFO-B).
(4) Gp
Fast VFO tuning rate is active.
(5)
This indicates that dual-receive operation is
activated.
(6)
This indicator appears whever split-frequency
operation is activated (by pressing the SPLIT but-
ton).
(7)
Front panel tuning knob and/or buttons are
locked.
(8) Gap
This appears whenever general coverage tun-
ing is selected (when tuning outside an amateur
band).
(9) Tuning Offset Scale
Displays sub-resolution tuning steps or clarifier
offset in segmented increments.
page 16
= a ran ts om 0 0
[QMB |] "fo if ea ee
mo 25 26 27
(10) QmMB (Quick Memory Bank)
Indicates stored memories from the Quick
Memory Bank are active for recall and operation.
(11)
VFO tuning or VFO operation is selected.
(12) MEM)
This indicator shows that memory operation is
selected (by pressing ("feu]).
(13)
Appears while retuning a selected memory
channel.
(14) ORPDS
One of these segments lights along with the
indicator when the repeater function is acti-
vated in the FM mode, indicating the direction of
TX offset.
(15) Frequency Display
This displays the current operating frequency,
and also provides alphanumeric chracter display
of programming menu selections and settings.
(16)
This indicator comes on when the ATU is acti-
vated and in-line.
(17)
Appears when the ATU is seeking the best
impedance match with the antenna. It also flashes
each time the transceiver microprocessor sends
frequency update data to the ATU microprocessor
(while you tune).