Switching Input Signal - BenQ MP612C User Manual

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
Please decide if you want to activate the quick auto search function by performing the
following steps.
1. Press Menu/exit on the projector or remote control to turn on the OSD menu.
2. Go to SOURCE > Quick Auto Search menu.
3. Press
4. Press MENU/exit to exit and save the settings.
• After activating Quick Auto Search, the
projector will perform automatic source
search once you press SOURCE on the
projector or remote control.
i. Press SOURCE on the projector or
remote control. A source selection bar
displays.
ii. Press
desired signal is selected and press
Mode/enter.
iii. The projector will start automatic
source search by detecting your selected
signal first.
iv. The information of the first detected
source will display at the upper left
corner of the screen for 2 seconds.
• If you turn off Quick Auto Search, you can manually cycle through the available
input sources by performing the following steps.
i. Press SOURCE on the projector or remote control. A source selection bar
displays.
ii. Press
enter.
iii. Once detected, the selected source information will display at the upper left
corner of the screen for 2 seconds. If there is multiple equipment connected to
the projector, you can press the button again to search for another signal.
• The brightness level of the projected image will change accordingly when you switch
between different input signals. Data (graphic) "PC" presentations using mostly static
images are generally brighter than "Video" using mostly moving images (movies).
The input signal type effects the options available for the Picture Mode. See
picture mode" on page 33
• The native display resolution of this projector is in a 4:3 aspect ratio. For best display
picture results, you should select and use an input source which outputs at this
resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity.
See "Selecting the aspect ratio" on page 32
Left or Right on the projector or remote control to select On or Off.
Up or Down until your
Up or Down until your desired signal is selected and press Mode/
for details.
D-Sub / Comp.
Video
S-Video
for details.
"Selecting a
Operation 29