Entering The Password Recall Procedure; Changing The Password; Disabling The Power-On Lock Function - BenQ MP612C User Manual

Entering the password recall procedure

Press and hold AUTO on the projector or remote
control for 3 seconds. The projector will display a
coded number on the screen. Write down the
number and turn off your projector. Seek help
from the local BenQ service center to decode the
number. You may be required to provide proof of
purchase documentation to verify that you are an
authorized user of the projector.

Changing the password

1. Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security Settings >
Change Password menu.
2. Press Mode/enter. the message 'INPUT CURRENT PASSWORD' displays.
3. Enter the old password.
i. If the password is correct, another message 'INPUT NEW PASSWORD' displays.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT CURRENT PASSWORD' displays for your
retry. You can press Menu/exit to cancel the change or try another password.
4. Enter a new password.
IMPORTANT: The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it
is available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
5. Confirm the new password by re-entering the new password.
6. You have successfully assigned a new password to
the projector. Remember to enter the new
password next time the projector is started.
7. To leave the OSD menu, press MENU/exit.

Disabling the power-on lock function

To disable password protection, go back to the SYSTEM SETUP: Advanced > Security
Settings > Power On Lock menu after opening the OSD menu system. Select Off by pressing
Left or
password.
i. If the password is correct, the OSD menu returns to the Security Settings page
with 'Off' shown in the row of Password. You will not have to enter the password
next time when turning on the projector.
ii. If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You can
press Menu/exit to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should
you ever need to re-activate the password function by entering the old password.
28 Operation
Right. The message 'INPUT PASSWORD' displays. Enter the current
RECALL PASSWORD
Please write down the recall code,
and contact BenQ Customer
Center.
Recall code:
Password Changed
0 2 1 2
Exit
MENU