Adjusting The Needle Up Stop Position - Brother Z-8550B Instruction Manual

Adjusting the needle up stop position

1
Press [ ] > [Memory switch setting].
The memory switch setting screen (1) will be
displayed.
2
Press or to select memory switch number
(No. 102).
3
Press or
(4) for the needle up stop position.
• If you press
increase up to 10 and the needle up stop
position will become lower.
• If you press
decrease down to -10 and the needle up stop
position will become higher.
• The default setting value is "0".
If the value that is displayed is different from the value that is currently set, the value in the display will flash.
• If you would like to return the setting to the initial value, press
• is only displayed when the setting value (the value being displayed) is different from the initial value.
4
Press (5).
The setting for the needle up stop position will be stored.
The setting display will change from flashing to illuminated. (This completes the needle up stop position
setting.)
• A setting value of "10" corresponds to an angle of rotation of approximately 10° for the upper shaft.
• If the needle bar is not at the needle up stop position, the needle up warning screen will be displayed.
(3) to change the setting value
, the setting value will
, the setting value will
.
60