Brother Z-8550B Instruction Manual page 140

11
Install the presser foot to presser bar tip A (17) or
presser bar tip B (18).
12
Install the spring guide collar (11), spring guide (9)
and spring (10).
13
Tighten the adjustment screw (8).
14
Loosen the screw (12) , align (21) the presser foot
with the groove in the needle plate (20), and then
carry out the adjustment in "Adjusting the presser
foot height".
To learn more, see Related Information.
When tightening the screw (12), lower the guide
bracket (13) until it is touching the lifter lever (19),
and then tighten the screw (12).
15
Install the face plate (6) with the screws (4) and the screw (5).
16
Install the thread take-up guard (3) with the screws (2).
Related Information
• Adjusting the height of the presser foot on page 107
• Points to note when installing optional parts on page 125
127