Adjusting The Needle Up Stop Position - Brother S-7220D Instruction Manual

1
Press [ ] > [Home screen mode
setting].
2
Press or to change the value.
3
Press .
Press this to return to the Home screen.
Adjusting the needle up stop
position
1
Press [ ] > [Memory switch setting].
The memory switch setting screen (1) will be
displayed.
2
Press or to select memory switch
number (No. 102).
3
Press or (3) to change the setting
value (4) for the needle up stop position.
• If you press , the setting value will
increase up to 10 and the needle up stop
position will become lower.
• If you press , the setting value will
decrease down to -10 and the needle up stop
position will become higher.
• The default setting value is "0".
If the value that is displayed is different from the
value that is currently set, the value in the display
will flash.
• If you would like to return the setting to the
initial value, press
• is only displayed when the setting value
(the value being displayed) is different from the
initial value.
4
Press (5).
The setting for the needle up stop position will be
stored.
The setting display will change from flashing to
illuminated. (This completes the needle up stop
position setting.)
• A setting value of "10" corresponds to an angle
of rotation of approximately 10° for the upper
shaft.
• If the needle bar is not at the needle up stop
position, the needle up warning screen will be
displayed.
.
29