IBM J15 Manual page 45

• Read and follow the guidelines that are described in "Weight considerations: 5U92 disk enclosure" on
page 12.
• Ensure that a suitably rated mechanical lift is available to support the weight of the expansion enclosure
as it inserted into the rack for installation.
About this task
The 5U92 disk enclosure and most parts are shipped together in one large box. A tray on the top of the
enclosure contains the front fascia (1U and 4U pieces), the cable management arm (CMA), and the slide
rail kit; you must install these parts. Figure 1 on page 17 shows how the enclosure is packaged for
shipment.
Figure 1. Tray containing disk enclosure parts
1 Slide rail kit
2 Cable management arm
3 Fascia
Other parts, such as the cover, secondary expander modules, and fans, are installed in the enclosure.
However, due to weight considerations, you must remove some parts and then reinstall them as part of
the initial installation process.
Note: Drives are not included in installation package for the enclosure; they are provided in a separate
package.
Procedure
1. Remove the cardboard tray that contains the slide rails, cable management arm, and fascia from the
cardboard box in which the disk enclosure was shipped.
2. Remove the foam end pieces from the top of the 5U92 disk enclosure.
3. Cut the corners of the shipping box and fold them down to uncover the sides and faces of the disk
enclosure, as shown in Figure 2 on page 17.
Figure 2. Packaging materials
1 Enclosure
Chapter 2. Installing the system hardware 17