Table of Contents
Advertisement
Figure 61. Installing the network daughter card
Next steps
Follow the procedure listed in
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the safety instructions that came with your system for more information.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the expansion card riser
Steps
1. Locate the battery socket. For more information, see the
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
2. Use a plastic scribe to pry out the system battery.
62
PowerEdge C4140 installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
1.
on page 24.
on page 23.
on page 24.
System board jumpers and connectors
section.
Advertisement
Table of Contents
