Table of Contents
Advertisement
Figure 31. Installing a cooling fan
Next steps
1.
Install the air
shroud..
2. Follow the procedure listed in
Hard drives
Removing the 2.5-inch drive cage
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Disconnect the power and signal cable from the system board.
4. Keep the Phillips #1 screwdriver ready.
Steps
1. Disconnect the cables from the system board.
2. Remove the screw securing the drive cage to the chassis.
3. Slide the drive cage out of the drive cage slot.
After working inside your system
Safety instructions
Before working inside your
PowerEdge C4140 installing and removing system components
on page 24.
section.
system.
33
Advertisement
Table of Contents
