Table of Contents
Advertisement
Figure 58. Installing the heat sink onto the processor
Next steps
1.
Install the processor and heat sink
2.
Install the air
shroud.
3. Follow the procedure listed in
Installing a processor and heat sink module
Prerequisites
CAUTION:
Never remove the heat sink from a processor unless you intend to replace the processor. The heat
sink is necessary to maintain proper thermal conditions.
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the
heat sink to cool before removing it.
1. Follow the safety guidelines listed in
2. If installed, remove the processor/DIMM blank and CPU dust cover.
The procedure to remove the processor/DIMM blank is similar to that of the memory module.
Steps
1. Align the pin 1 indicator of the heat sink to the system board and then place the processor and heat sink module (PHM) on
the processor socket.
CAUTION:
To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
NOTE:
Ensure that the PHM is held parallel to the system board to prevent damaging the components.
2. Push the blue retention clips inward to allow the heat sink to drop into place.
3. Supporting the heat sink with one hand.
module.
After working inside your system
Safety instructions
PowerEdge C4140 installing and removing system components
on page 24.
on page 23.
59
Advertisement
Table of Contents
