Table of Contents
Advertisement
Figure 92. Installing the SXM2-GPU heat sink
4. Using a Philips #2 screwdriver tighten the screws in the following order to secure the heat sink to the system board:
a. Tighten the first screw three turns.
b. Tighten the screw diagonally opposite to the screw you tightened.
Figure 93. Installing the SXM2-GPU heat sink screws
5. Repeat the procedure for the remaining two screws.
6. Return to the first screw and tighten it.
88
PowerEdge C4140 installing and removing system components
Advertisement
Table of Contents
