Sxm2 Graphics Processing Unit; Removing The Nvlink Air Shroud - Dell EMC PowerEdge C4140 Installation And Service Manual

3. GPU 6 power cable
5. GPU 7signal cable
7. GPU 4 and 5 cables on the system board
9. GPU 4 power cable

SXM2 Graphics processing unit

The following are the high-level steps that you must perform to replace the SXM2 GPUs:
1. Remove the NVLink air shroud.
2. Remove the SXM2 heat sink.
3. Remove the SXM2 GPU.
4. Remove the NVLink Board.
5. Install the NVLink Board.
6. Install the SXM2 GPU.
7. Install the SXM2 heat sink.
8. Install the NVLink air shroud.

Removing the NVLink Air Shroud

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
Lift and remove the NVLink air shroud from the NVLink board.
Figure 83. Removing NVLink air shroud
80 PowerEdge C4140 installing and removing system components
Safety instructions
Before working inside your
4. system board
6. GPU 6 and 7 cables on the system board
8. GPU 4 signal cable
10. GPU 5 power cable
section.
system.