Table of Contents
Advertisement
Installing an expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
2. if applicable,
install an expansion card into the riser
Steps
1. Holding the blue touch points on the expansion card riser, align the expansion card with the connector on the system board.
NOTE:
While installing riser 1, press the tabs and hold the touch point to align the expansion card riser and the riser
guide pin on the system board.
2. Lower the expansion card riser into place until the expansion card riser is fully seated with the connector on the system
board.
Figure 45. Installing expansion card riser 1
Safety instructions
on page 23.
before installing the expansion card riser 2.
PowerEdge C4140 installing and removing system components
49
Advertisement
Table of Contents
