Removing The 2.5-Inch Drive Cage Cover - Dell EMC PowerEdge C4140 Installation And Service Manual

Figure 33. Installing the 2.5-inch drive cage
Next steps
1. Connect the power cable to the system board.
2. Connect the signal cables to the system board or expansion card.
3. Follow the procedure listed in

Removing the 2.5-inch drive cage cover

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the 2.5-inch drive
4. Keep the Phillips #1 screwdriver ready.
Steps
1. Remove the screws securing the drive cage cover to the drive cage.
2. Slide the drive cage cover toward the front of the drive cage to disengage it from the slots on the drive cage.
3. Lift the drive cage cover away from the drive cage.
After working inside your
Safety instructions
Before working inside your
cage.
PowerEdge C4140 installing and removing system components
system.
section.
system.
35