Table of Contents
Advertisement
2.2.1
FCC Conformity
US Installations only: Federal Communications Commission (FCC) rules
Note
• This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment.
• This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the operating instructions, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference to radio communications, in which case the user will
be required to correct the interference at his own expense.
Canada Installations only: Industry Canada (IC) rules
NOTICE
Use on a "no-interference, no-protection" basis
The installation of the LPR/TLPR device shall be done by trained installers, in strict
compliance with the manufacturer's instructions.
• The use of this device is on a "no-interference, no-protection" basis. That is, the user
2.2.2
CE Electromagnetic Compatibility (EMC) Conformity
This equipment has been tested and found to comply with the following EMC Standards:
EMC Standard
CISPR 11:2009 + A1:2010/EN
55011:2009 + A1:2010, CLASS A
EN 61326:2013
(IEC 61326:2012)
EN61000-4-2:2009
EN61000-4-3:2006 + A1:2008 +
A2:2010
EN61000-4-4:2004 + A1:2010
EN61000-4-5:2006
SITRANS LR200 with mA/HART
Operating Instructions, 05/2019, A5E32337676-AE
shall accept operations of high-powered radar in the same frequency band which may
interfere with or damage this device. However, devices found to interfere with primary
licensing operations will be required to be removed at the user's expense.
Title
Limits and methods of measurements of radio disturbance char-
acteristics of industrial, scientific, and medical (ISM) radio-
frequency equipment.
Electrical Equipment for Measurement, Control and Laboratory
Use – Electromagnetic Compatibility.
Electromagnetic Compatibility (EMC) Part 4-2: Testing and
measurement techniques – Electrostatic discharge immunity test.
Electromagnetic Compatibility (EMC) Part 4-3: Testing and
measurement techniques – Radiated, radio-frequency, electro-
magnetic field immunity test 2006 + A1:2008 + A2:2010.
Electromagnetic Compatibility (EMC) Part 4-4: Testing and
measurement techniques – Electrical fast transient/burst immunity
test.
Electromagnetic Compatibility (EMC) Part 4-5: Testing and
measurement techniques – Surge immunity test.
Safety notes
2.2 Laws and directives
13
Advertisement
Table of Contents
Troubleshooting
