Maximum Volume (2.7.1.2.); Dimension A (2.7.1.3.) - Siemens SITRANS LR200 7ML5422 Operating Instructions Manual

Vessel shape
Linearization Table must be selected in order for level/volume values to be transferred. For
more detail, refer to Table 1-8 (2.7.2.) (Page 109).
7.2.6.3

Maximum volume (2.7.1.2.)

Description
Values
Factory setting
Related
parameters
7.2.6.4

Dimension A (2.7.1.3.)

Description
Values
Factory setting
Related parame-
ters
108
LCD Display/
description
FLAT SLOPED BOTTOM
PARABOLIC ENDS
Parabolic end horizontal cylinder
LINEAR TABLE
Linearization table (lev-
el/volume/breakpoints)
The maximum volume of the vessel. Enter the vessel volume corresponding to
High Calibration Point. For example, if your maximum vessel volume is 8000 L,
enter a value of 8000. Volume units are defined by the user but are not explicitly
stated in the device.
Range: 0.0000 to 99999
100.0
Low calibration point (2.3.1.) (Page 100)
High calibration point (2.3.2.) (Page 101)
Vessel shapes (2.7.1.1.) (Page 107)
The height of the vessel bottom when the bottom is conical, pyramidal, parabol-
ic, spherical, or flat -sloped. If the vessel is horizontal with parabolic ends, the
depth of the end. For an illustration, refer to Vessel shapes (2.7.1.1.) (Page 107).
0.0000 to 999999 mm
0.0
UNITS (1.4.)
Vessel shapes (2.7.1.1.) (Page 107)
Also required
maximum volume, dimension A
maximum volume, dimension A,
dimension L
maximum volume, tables 1-32
1)
level and volume breakpoints
SITRANS LR200 with mA/HART
Operating Instructions, 05/2019, A5E32337676-AE