Fcc And Ic Conformity - Siemens SITRANS LR460 HART Operating Instructions Manual

FCC, RED and IC Conformity
US Installations only: Federal Communications Commission (FCC) rules
WARNING: Changes or modifications not expressly approved by
Siemens Milltronics could void the user's authority to operate the
equipment.
Notes:
• This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
• This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference to radio communications, in which case
the user will be required to correct the interference at his own expense.
Radio Equipment Directive (RED) compliance (Europe)
Hereby, Siemens declares that the SITRANS LR460 is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU.
The LR460 complies with EN 302 372 for use in closed storage vessels, when installed
according to the installation requirements of EN 302 372, and may be used in all EU
countries.
For the receiver test that covers the influence of an interferer signal to the device, the
performance criterion has at least the following level of performance according to ETSI
TS 103 361 [6]:
• Performance criterion: measurement value variation ∆d over time during a distance
measurement
• Level of performance: ∆d ≤ ±50 mm
Canadian Installations only: Industry Canada (IC) rules
Notes:
• This device shall be installed and operated in a completely enclosed container to
prevent RF emission, which otherwise can interfere with aeronautical navigation.
Installation shall be done by trained installers, in strict compliance with the
manufacturer's instructions.
• The use of this device is on a 'no-protection non-interference' basis.
- The user shall accept operations of high powered radar in the same frequency
band, which may interfere with or damage this device.
- The user is responsible for removing, at the user's expense, any device found to
interfere with primary licensing operations.
Page 2 SITRANS LR460 – INSTRUCTION MANUAL A5E42035355