Braking system fluid top up
CAUTION
TO HAVE THE BRAKING SYSTEM FLUID TOPPED-UP, PLEASE CONTACT AN
Official Aprilia Dealer. IF YOU ARE SUITABLY AND EXPERIENCED, FOLLOW
THE INSTRUCTIONS IN THE WORKSHOP BOOKLET, WHICH IS AVAILABLE
FROM ANY DEALER.
Battery removal (04_22, 04_23)
•
Open the helmet compartment.
•
Make sure that the ignition switch is set to "OFF".
•
Undo and remove the two screws fixing the battery cover (1).
•
Remove the battery cover (2).
•
Unscrew and remove the screw (3) of the negative terminal (-).
•
Move the negative lead (4) aside.
•
Unscrew and remove the screw (5) of the positive terminal (+).
•
Move the positive lead (6) aside.
•
Hold the battery (7) firmly and lift it out of its compartment.
04_22
•
Put the battery (7) away on a level surface in a cool and dry place.
CAUTION
UPON REFITTING, CONNECT THE LEAD TO THE POSITIVE TERMINAL (+) FIRST
AND AFTERWARDS THE LEAD TO THE NEGATIVE TERMINAL (-).
CHECK THAT THE BATTERY LEADS AND TERMINALS ARE:
- IN GOOD CONDITION (NOT CORRODED OR COVERED BY DEPOSITS);
04_23
- COVERED BY NEUTRAL GREASE OR PETROLEUM JELLY.
95