Kenwood NX-200 Service Manual page 28

NX-200
■ After repairing and reassembling
After repairing and reassembling, apply bond to the top
of the left side screw for the chassis and between the
chassis and the left side screw for the option board cov-
er.
Note:
• Take care that the bond does not protrude above the
chassis surface. (Take care that the bond does not
come into contact with the battery.)
• Use a silicon based bond.
28
DISASSEMBLY FOR REPAIR /
Bond
粘合剂
维修拆卸
New black sheet / 新黑色薄片
New water-resistant sheet / 新防水片
■维修并重新组装之后
维修并重新组装之后，在底座左侧螺丝的上面和底座与可
选板盖的左侧螺丝之间涂上粘合剂。
注意 :
• 注意不要使粘合剂突出于底座表面之上。( 注意不要使粘
合剂与电池接触。)
• 使用硅基粘合剂。