Kenwood NX-200 Service Manual page 15

DISASSEMBLY FOR REPAIR /
■ Removing the TOP packing (G53-1762-02)
1. Pull the TOP packing to the left to remove the packing
that is fi t into the left groove of the chassis q.
2. Pull the TOP packing to the right to remove the packing
that is fi t into the right groove of the chassis w.
3. Turn back the TOP packing as shown in the fi gure e.
4. Remove the TOP packing r.
Note:
Take care not to damage the TOP packing when peeling
off, as it is attached to the chassis with two pieces of
double-sided adhesive tape (J99-0727-04, J99-0728-04).
Note:
The two pieces of double-sided adhesive tape attached
to the TOP packing cannot be reused.
Perform the following procedures when you reassemble
the TOP packing.
1) Attach the TOP packing after attaching new double-
sided adhesive tape to the chassis as shown in the
fi gure.
IP67
Double-sided adhesive tape
双面胶带
(J99-0728-04)
维修拆卸
■拆下顶盖 (G53-1762-02)
1. 向左拉顶盖，拆下装在底座左侧凹槽内的盖 ①。
2. 向右拉顶盖，拆下装在底座右侧凹槽内的盖 ②。
3. 如图所示回转顶盖 ③。
4. 取下顶盖 ④。
注意 :
剥离时小心不要损坏顶盖，因为顶盖通过两块双面胶带
(J99-0727-04,J99-0728-04) 贴在底座上。
注意 :
贴在顶盖上的两块双面胶带不能重新使用。
重新组装顶盖时，请执行以下操作。
1) 如图所示在底座上贴上新的双面胶带之后，再安装顶盖。
TOP packing / 顶盖
IP67
Double-sided adhesive tape
双面胶带
(J99-0727-04)
NX-200
15