Removing The Power Supply Adapter; Using A Power Supply Adapter In An Enterasys Wireless Outdoor Ap - Enterasys AP2650 Installation Manual

Fitting a Power Supply Adapter
Figure 3-5
2. Connect the power supply adapter and the Enterasys Wireless Outdoor AP with the screw
supplied with the power supply adapter (position A in Figure
3. Connect the cable for the power supply. The assignment of the contacts is depicted in
Figure
4. Secure the power supply cable with a strain relief clamp.

Removing the Power Supply Adapter

To remove a power supply adapter from the Enterasys Wireless Outdoor AP:
1. Disconnect the power supply cable from the power supply adapter.
2. Loosen the securing screw of the power supply adapter (Position A in Figure
3. Pull the loop (Position B in the Figure
supply adapter from the socket in the housing and remove the power supply adapter.
3-8 Connecting Cables to the Enterasys Wireless Outdoor AP

Using a Power Supply Adapter in an Enterasys Wireless Outdoor AP

Caution: Only use the loop (Position B in
Enterasys Wireless Outdoor AP. This prevents the connector skewing on the back of the power
supply adapter and breaking off.
3‐5.
Disconnect power supply cables only when the power to the power supply
Warning:
adapter is turned off!
Figure 3-5) to remove the power supply adapter from the
3‐5) to remove the connector on the rear of the power
3‐5).
3‐5).