Connecting an External Antenna Cable to the Enterasys Wireless Outdoor AP
Figure 3-7
2.
Screw a terminating resistor to the unused socket if you use only one antenna on a port.
3.
Secure the antenna cable(s) with a strain relief clamp.
3-10 Connecting Cables to the Enterasys Wireless Outdoor AP
Ports for External Antennas, with the Housing Cover Removed
Note: "R1" is mapped to Radio 1 and "R2" is mapped to Radio 2 on the user interface of the
Enterasys Wireless Controller.
The Antenna "A" connector is mapped to the Right antenna and the Antenna "B" connector is
mapped to the Left antenna on the user interface of the Enterasys Wireless Controller.