Enterasys Wireless Outdoor Aps Leds; Reset Button; Enterasys Wireless Outdoor Ap Leds - Enterasys AP2650 Installation Manual

Table 1-2 Enterasys Wireless Outdoor AP Accessories List (continued)
Product
IWLAN Rcoax N-
Connect/SMA Female/
Female Panel
Feedthrough
IWLAN Termination
ImpedanceTI795-1R
(Three pieces)

Enterasys Wireless Outdoor APs LEDs

The frontal view of the housing cover displays six LEDs. These LEDs provide information on
operating status. For more information, see the Enterasys Wireless Controller, Access Points and
Convergence Software User Guide.
Figure 1-2

Reset Button

The reset button is located below the housing cover beside the sockets for external antennas as
depicted in Figure
button.
Description
Cabinet feedthrough (SMA female to N female) 6GK5798-0PT00-2AA0
Termination Impedance (terminator)

Enterasys Wireless Outdoor AP LEDs

Note: Although the Enterasys Wireless Outdoor AP has six LEDS, only R1, R2 and F LEDs are
used in the current release. The remaining LEDs are disabled.
1‐3 on page 1‐4. You must remove the housing cover to gain access to the reset
Warning: You must remove the housing cover only after you have turned off the power supply of
the Enterasys Wireless Outdoor AP. After you have removed the housing cover, you must turn the
power on to use the reset button.
Enterasys Wireless Outdoor APs LEDs
Order # (ordered from
Siemens A&D)
6GK5795-1TR10-0AA6
Enterasys Wireless Outdoor AP Installation Guide 1-3