Reset Speakerphone - Lucent Technologies Definity 8410 User Manual

DEFINITY® ECS Release 5 8410 Voice Terminal User's Guide 555-230-763

Reset Speakerphone

Important: You can use this feature only if the Reset Spkr label appears under the
Speaker button and if your voice terminal is set for the Speakerphone feature (as opposed
to the Speaker feature). If you do not have a Shift button or the Reset Spkr label on your
8410, you do not need to activate this feature.
If your 8410 is equipped with this feature, you can adjust the speakerphone to the
surrounding room acoustics to provide optimal performance. Use the Reset
Speakerphone feature in the following ways:
Whenever you move your voice terminal to another place (even in the same room)
Whenever the red light next to
Note: You may also use this feature when you are on a call in the unlikely event
your speakerphone makes a squealing noise during the call. Your speakerphone
will adjust itself to normal for that call. (No tones will be heard.)
Important: If there has been an interruption in power (such as, the system has just
been powered up again, or you have plugged in the voice terminal at another
location), the light next to
You can initiate the Reset Speakerphone feature when your handset is on-hook, or during
a call in which you are using the built-in speakerphone. (If a call is in progress, you will not
hear the tones, and the new speakerphone adjustment is reset for only the duration of that
call.)
Speaker is fluttering
flutters until you reset the built-in speakerphone.
Speaker
Issue 2
June 1997
Page 63