Resetting The Speakerphone With The Softkeys (When Powering Up The Voice Terminal) - Lucent Technologies Definity 8405 User Manual

Resetting the Speakerphone with the Softkeys
(When Powering Up the 8405D Plus Voice Terminal)
Important: You can use the Reset Speakerphone feature only if your voice terminal
has the Reset Spkr label printed under the
Note: The following procedure can be used only the 8405D Plus voice terminal,
since it has a display and softkeys.
When you first power up the 8405D Plus voice terminal, the following display
appears.
When you reset the speakerphone on your voice terminal, you hear a set of tones as
the speakerphone performs an acoustic test of the environment. When the tones
stop, your speakerphone has finished adjusting itself for optimal performance and is
ready for use. For more information about the Reset Speakerphone feature, see
"Reset Speakerphone" in the section Voice Feature Procedures later in this guide.
To reset the speakerphone
(when those 8405D Plus
voice terminals with the
Reset Spkr label are
first powered up)
Speaker
PLEASE RESET SPKR.
Begin
1
Press the softkey below Begin to reset the
speakerphone
(Press the softkey below Cancel if you do not want to
reset the speakerphone at this time. However, note
that the red light next to
flutter.)
If you press the softkey below Begin, the 8405D
Plus display shows the following timed screen:
OPTIMIZING PERFORMANCE
OF THE SPEAKERPHONE.
You will hear a set of rising tones as the
speakerphone adjusts itself to the surrounding
acoustical environment. These tones are
automatic. No user response is required.
button.
Cancel
will continue to
Speaker
17