Install The Upper Foam Epac; Installing An Add-In Board - Intel SC5000 Subassembly Product Manual

Install the Upper Foam Epac

1. If the hot swap bay is installed, connect the SCSI I2C cable to it.
2. Connect data and power cables to the diskette drive.
3. Make sure the fan cables are in their slots in the lower foam epac.
4. The power cables for the lower IDE drive bays run behind the foam epac. If the hot swap bay
is installed, they run over the bay.
5. Place the upper part of the foam epac into the chassis. The SCSI I2C and diskette drive data
cables should lay over it.
6. Press the foam epac into place. You may need to wiggle the fans to get it to sit flush with the
lower foam epac.
7. Tilt the side of the upper foam epac that is against the chassis (the side farthest away from the
power supply) up so it forms an opening between the foam epac and the slotted access cover
support rail on the chassis.
8. Lay the SCSI I2C and diskette drive data cables in this gap on the shoulder of the foam epac.
9. Being careful not to pinch the cables, tilt the foam epac back into place.
36
B
C
Figure 23. Installing an Add-in Board
A. Snap-in slot cover
B. Tapered foot
C. Slot
Intel SC5000 Server Chassis Subassembly Product Guide
A
OM09171