Saf-Te Card And Hot Swap Backplane - Intel SC5000 Subassembly Product Manual

11. If you are replacing the hot swap backplane, do the following:
a. Remove the SAF-TE card from the old hot swap backplane.
b. Plug the SAF-TE card into the new hot swap backplane.
12. If you are replacing the SAFE-TE card, do the following:
a. Remove the old SAF-TE card from the hot swap backplane.
b. Plug the new SAF-TE card into the hot swap backplane.
13. Carefully slide the SAF-TE card/hot swap backplane assembly into place on the hot swap bay.
There are two notches on the bay that the SAF-TE card slides through.
14. Place the bracket on the backplane.
15. Insert and tighten the four screws that hold the backplane in place.
16. Slide bay half way into the chassis.
17. Connect the SCSI cable to the backplane.
18. Slide the bay the rest of the way into the chassis.
19. Insert and tighten the six screws that hold the bay in the chassis.
20. Connect the power cables and I2C cable to the backplane.
21. Install the top half of the foam epac.
22. Replace the access cover.
23. Replace the hot swap drives and carriers.
Working Inside Your Server
Figure 35. SAF-TE Card and Hot Swap Backplane
OM09181
51