Install The I/O Shield; Installing The I/O Shield - Intel SC5000 Subassembly Product Manual

Install the I/O Shield

NOTE
An ATX 2.03-compliant I/O shield is provided with the server board. The
shield is required by Electromagnetic Interference (EMI) regulations. It
minimizes EMI and ensures proper cooling of the server. If the shield does
not fit the chassis, obtain a properly sized shield from the chassis supplier.
The shield fits the rectangular opening near the power supply in the back of the chassis. The shield
has cutouts that match the external I/O connectors (e.g., keyboard and mouse).
1. Install the shield from inside the chassis. Orient the shield so that the cutouts align with the
corresponding I/O connectors on the server board. Make sure the metal fingers are on the
inside of the chassis.
2. Position one edge so that the dotted groove is outside the chassis wall, and the lip of the shield
rests on the inner chassis wall.
3. Hold the shield in place, and push it into the opening until it is seated. Make sure the I/O
shield snaps into place all the way around.
Setting Up the Chassis
Figure 8. Installing the I/O Shield
OM09079
17