Table of Contents
Advertisement
Install the Server Board
CAUTION
Do not install any server board support bumpers in the SR2300 chassis.
System components must be installed in the order presented below. If
installed in a different order, component damage may occur.
1. Ensure that the insulator sheet is seated securely over the standoffs, is laying flat on the
chassis floor, and that the edge of the sheet is seated below the studs in the rear chassis wall.
(Figure 10, A.)
2. Remove the server board from its packaging and antistatic bag.
3. While placing the board on the chassis standoffs, carefully position the board I/O connectors
(Figure 10, B) in the rear chassis I/O openings.
4. Adjust board position so that the mounting holes rest securely on the corresponding
shouldered standoffs (Figure 10, C).
5. Attach the board to the chassis using the three screws shipped in the chassis accessory kit
(Figure 10, D).
Assembling the System
25
Advertisement
Table of Contents
