Mounting; Tabletop Placement; Rack Mounting; Ul Guidelines For Rack Mounted Devices - Extron electronics DVS 605 Series User Manual

Mounting

This section describes:
•
•
•
If the DVS 605 is to be rack mounted, it is important to mount it before cabling it. Four
rubber feet are included with the unit. Install the feet only if the unit is to be mounted on a
tabletop (see Tabletop Placement below).

Tabletop Placement

For tabletop placement, install the adhesive rubber feet or pads (provided) onto the four
corners of the bottom of the device.

Rack Mounting

UL Guidelines for Rack Mounted Devices

The following Underwriters Laboratories (UL) guidelines pertain to the safe installation of
the device in a rack.
1.
2.
3.
4.
5.
Tabletop Placement
Rack Mounting
Furniture Mounting
Elevated operating ambient temperature — If installed in a closed or multi-unit
rack assembly, the operating ambient temperature of the rack environment may
be greater than room ambient temperature. Therefore, install the device in an
environment compatible with the maximum ambient temperature (Tma = +122 °F,
+50 °C) specified by Extron.
Reduced air flow — Install the equipment in a rack so that the amount of air flow
required for safe operation of the equipment is not compromised.
Mechanical loading — Mount the equipment in the rack so that a hazardous
condition is not achieved due to uneven mechanical loading.
Circuit overloading — Connect the equipment to the supply circuit and consider the
effect that circuit overloading might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be used when
addressing this concern.
Reliable earthing (grounding) — Maintain reliable grounding of rack-mounted
equipment. Pay particular attention to supply connections other than direct
connections to the branch circuit (such as use of power strips).
DVS 605 • Mounting 123