Installation And Basic Operation; Mounting; Rear Panel Connections And Features - Extron electronics NAV E 511 User Manual

Installation and
Basic Operation
This section describes the installation and the operation of the NAV E 511 encoder,
including:
•
•
•
•

Mounting

If desired, mount the encoder in a rack (see

Rear Panel Connections and Features

INPUT
POWER
12V
2.0 A MAX
HDMI LOOP THRU
J J J A A A
Figure 2.
A
B
C
D
E
A
B
C
Mounting
Rear Panel Connections and Features
Front Panel Features
Startup and Basic Operation
AUDIO
L R CONT
C T Tx Rx G S G
B B B C C C D D D
NAV E 511 Rear Panel Connectors and Features
HDMI input port
LOOP THRU port
AUDIO input port
CONTROL Contact Closure port
CONTROL RS-232/IR port
HDMI input port — Connect an HDMI cable between this port and the
HDMI output port (or DVI port, with an appropriate adapter) of the digital
video source (see LockIt Lacing Brackets
HDMI Cable Lacing Bracket to secure the connector to the encoder).
LOOP THRU port — Connect a display to this female HDMI connector
for local loop-through monitoring of the source signal (see
Brackets).
AUDIO input port — Connect balanced or unbalanced stereo audio
input to this 5-pole, 3.5 mm captive screw connector (see
Analog audio connectors
Mounting the Encoder
CONTROL USB 2.0
RS-232 IR
5V/500 mA
E E E F F F
F USB 2.0 port
G NAV 1G port
H Extension port
I
RESET button and LED
J Power connector
on page 9 to use the LockIt
on page 10 to wire the connector).
NAV E 511 Encoder • Installation and Basic Operation
on page 78).
NAV E 511
LAN
RESET
NAV 1G EXT
G G G H H H I I I
HDMI
LockIt Lacing
LOOP THRU
AUDIO
L R
6