Download Print this page

Sony VENICE CineAltaV MPC-3610 Update Manual page 5

Digital motion picture camera
Hide thumbs Also See for VENICE CineAltaV MPC-3610:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
000 5
Version Upgrade using
Recovery Mode (Forced
Version Upgrade)
If the user version upgrade fails, a problem may
have occurred in internal memory. The problem in
internal memory may also have occurred due to
another error. When a problem in internal memory
occurs, an error may be issued or the MPC-3610
may not turn on. In such cases, you can forcibly
write the software to the MPC-3610 using recovery
mode. The MPC-3610 will operate normally once
the problem is resolved.
[Notes]
ˎ Executing the procedure in this section will restore the
ˎ
MPC-3610 software to factory defaults, and user settings
will be lost. User settings are maintained in a normal
version upgrade, so you should upgrade from the setup
menu.
ˎ Always connect an AC adaptor (AC-DN2B, AC-DN10)
ˎ
when upgrading. If a battery pack is attached at the
same time, the upgrade will continue if the AC adaptor is
subsequently disconnected.
ˎ If the problem persists after recovery using this function,
ˎ
contact a Sony service representative.
Required item
Prepare an SD card or SDHC card on which the
version upgrade data is saved.
Procedure
1
Insert the SD card into the MPC-3610.
[Note]
Set the power switch of the MPC-3610 to the OFF
position, and then insert the SD card.
2
Press and hold the MENU button together
with the CLIPS and ASSIGN 2 buttons on the
Assistant side, and set the power switch to the
ON position.
The REC lamp of the MPC-3610 starts flashing
and the software recovery begins.
When finished, the REC lamp stops flashing
and the MPC-3610 automatically restarts.
[Notes]
ˎ When the REC lamp starts flashing, release the
ˎ
buttons.
ˎ The version upgrade process using recovery mode
ˎ
takes about 45 minutes.
ˎ The version upgrade progress may not be displayed
ˎ
depending on the state of the unit.
3
Turn the MPC-3610 off.
4
Remove the SD card from the MPC-3610.
5
Turn the MPC-3610 on, and check that the unit
starts normally.
6
Check that the version has been updated (see
"Checking the Existing Version").
GB

Advertisement

loading