Siemens Simatic ET 200SP Equipment Manual page 85

Integrated Functions
Number of counters
Counting frequency (counter) max.
Safety monitoring functions
Safe Operating Stop (SOS)
Safely-Limited Speed (SLS)
Safe Direction (SDI)
Safe Speed Monitor (SSM)
Counting functions
Continuous counting
Counter response parameterizable
Software gate
Counting range, parameterizable
Measuring functions
Measuring range
Frequency measurement, min.
Frequency measurement, max.
Cycle duration measurement, min.
Cycle duration measurement, max.
Velocity measurement, min.
Velocity measurement, max.
Accuracy
Frequency measurement
Cycle duration measurement
Velocity measurement
Potential separation
Potential separation channels
between the channels
between the channels and backplane bus
Between the channels and load voltage L+
between the channels and the power supply of
the electronics
Isolation
Isolation tested with
Degree and class of protection
IP degree of protection
Standards, approvals, certificates
Suitable for safety functions
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
Equipment Manual, V1.0, 01/2021, A5E47073911-AA
Technical specifications
6ES7136-6CB00-0CA0
1
800 kHz; with quadruple evaluation
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Hz
800 kHz
1 μs
25 s
0; (user defined units)
2147483; +/- (user defined units)
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
Up to 100 ppm; depending on measuring interval
and signal evaluation. At low frequency external
noise may have an effect on accuracy (reference
the graph in 2.2.3)
No; Only one channel is available
Yes
No
No
707 V DC (type test)
IP20
Yes
7.1 Specifications
83