Responding To Sdi; Address Space - Siemens Simatic ET 200SP Equipment Manual

Parameters/address space

4.10 Address space

4.9.3.3

Responding to SDI

Your safety program examines the "Safe Direction Event" bit and takes appropriate action
when the bit is seen as 1. Once set, the "Safe Direction Event" bit remains set until either of
the following actions occur:
• Your safety program sets the "Reset Safe Direction" bit to 1
• A power cycle
• A new STEP 7 hardware configuration is downloaded
4.10 Address space
Address space of the technology module
Table 4- 4
Range for control and feedback interface
Table 4- 5
Range for control and feedback interface
60
Size of input and output addresses of the F-TM Count for PROFIsafe version 2.4 (with S7-
300/S7-400)
Size of input and output addresses of the F-TM Count for PROFIsafe version 2.6.1 (with
S7-1200/S7-1500)
Control (Outputs)
6 bytes
Control (Outputs)
7 bytes
ET 200SP F-TM Count 1x1Vpp sin/cos HF (6ES7136-6CB00-0CA0)
Equipment Manual, V1.0, 01/2021, A5E47073911-AA
Feedback (Inputs)
14 bytes
Feedback (Inputs)
15 bytes