Table of Contents
Advertisement
10 Assembly and installation
2
13. After completing the electrical connection, carefully pull the connection cable taut.
14. Make sure that seal 1 is fitted correctly and is not damaged.
15. Put on cover 2 so that the bayonet fitting is inserted correctly and turn cover 2 clockwise.
16. Restore the power supply.
17. To check that everything is working correctly, open and close the valve and observe the signalling.
18. If the settings need to be readjusted, switch off power to the product again and repeat the steps in "Setting the switching
positions".
www.gemu-group.com
19 / 27
GEMÜ 4241
Advertisement
Table of Contents
