Adding Performance Midi To An Existing Preset - Art SGX-NightBass User Manual

REMOTE SWITCH 2
= DECR PROGS
EXAMPLE 5

Adding Performance MIDI to an existing preset.

In this example we are going to add PM to preset 45, "TV ON MARS". The effect
parameter we will control is: REV:DECAY, the reverb decay time of the preset. The
intended controller will be MC 4, Foot Controller. Now when the MIDI controller
is used, the decay time will change from 0.9s to 5.0s.
-Recall preset 45.
-Press the EDIT button.
-Use the Encoder to scroll up to preset 120.
-Press the Store button.
*You've just copied 45 to location 120.
-Press the ADD EFFECT button and turn the Encoder until you see [ADD:MIDI
CONTRL?].
-Press the ENTER button.
*You have just added a MIDI controller to the preset.
-Press the Param button four times.
-Press the Value button.
-Use the Encoder to select [REV:DECAY = 0.9s]
*The upper half of the display reads [#1 IS CONTROLING]
-Press the Value button again, DON'T CHANGE THIS VALUE.
-Press the Value button again.
-Use the Encoder to set the Low Value to [REV:DECAY = 0.9s]
-Press the Value button one more time.
-Use the Encoder to change the High Value to [REV:DECAY = 5.0s]
-Press the STORE button.
-Press the Edit button to escape to Preset Mode.
You now have edited a Factory Preset for PM control. You may edit any existing
preset to be controlled by PM. Remember to UNLOCK the preset to STORE your
changes and then re-lock the presets if you edit a factory preset at its original
location.
The MIDI controller assigned in this preset is MC 4, a foot controller. If you
are using your NIGHTBASS with an ART X-15 ULTRAFOOT, the left pedal will control
the master level of the preset.
9
51