Remote Switch 1 & 2; Auto Pm Display - Art SGX-NightBass User Manual

the through signal level will be whatever this value is set to. The initial
default setting is 100%.
When the value is set to [= MIX DRY LEVEL], the DRY level setting (from the
Programmable Mix) of the preset will be the signal level when the NIGHTBASS is
bypassed. Set your Bypass Level to avoid wild jumps in volume when kicking the
NIGHTBASS in and out.
REMOTE SWITCH 1 & 2
[= BYPASS ON/OFF]
The REMOTE jacks may be programmed to Bypass the NIGHTBASS, access the Increment
and Decrement Preset mode, and Re-Arm or Trigger the Sampler. A footswitch and
any two conductor cable is intended to be used with these jacks. If you are using
an ART X-15 ULTRAFOOT, you can use the Bypass Jack feature on the X-15 to control
one of the NIGHTBASS's Remote Jacks. A momentary (normally open) switch should be
used in applications other than the X-15's bypass feature.
Use the following chart to determine how the Remote Jacks may be programmed.
# REMOTE 1
0 BYPASS ON/OFF
1 SAMPLE-TRIGGER
2 INCR PROGS 2
3 N/A (no value)
Either jack may be programmed for the Bypass feature, each time the footswitch is
activated (hot connected to ground) the BYPASS function is accessed and acts like
the Bypass button on the front panel.
The jacks may also be programmed to allow a footswitch to be used for accessing
either the Trigger or Re-Arm function when using the Sampler program. Either
Remote 1 or Remote 2 can be assigned as the Trigger and Remote 2 may be assigned
as the Re-Arm.
These jacks may also be programmed to increment and decrement through a set of
presets. Remote 1 may be set for incrementing up and Remote 2 may be set for
decrementing down. For decrement program to work, you must program Remote 1 for
increment. You can not program the Remote 2 jack for decrement alone.
AUTO PM DISPLAY [ALWAYS ON]
OFF, PRESET ONLY, ALWAYS ON
This utility let's you set when the LCD displays Performance MIDI messages. When
set to OFF, no message is displayed when the NIGHTBASS receives Performance MIDI
messages. Preset Only allows messages to be displayed when in Preset Mode or when
editing a preset. Always On means the MIDI message will be displayed whenever the
NIGHTBASS receives a (Performance) MIDI message.
NOTE: The NIGHTBASS always receives MIDI messages and responds to them. Only the
display is affected when setting this value.
16
REMOTE 2
BYPASS ON/OFF
SAMPLE-TRIGGER
SAMPLER-ARM
DECR PROGS